Замразете процеса на сублимация на сушилнята
In the first stage of heating (mass sublimation stage), the temperature of the product is lower than its eutectic point by a range. Therefore, the shelf temperature should be controlled. If the product has been partially dried, but the temperature exceeds its eutectic point, the product will melt. At this time, the melted liquid is saturated with ice but not saturated with solute. The dried solute will dissolve in quickly, and finally concentrated into a thin and rigid block, which has a very bad appearance and a poor dissolution rate. If the melting of the product occurs in the late stage of a large number of sublimation, the amount of molten liquid will be small, so the dried porous solid Absorbed, resulting in some defects in the block after freeze-drying, and it can still be found that the dissolution rate is slow when adding water to dissolve. In the process of a large number of sublimation, although the temperature of the shelf and the product is very different, because the temperature of the plate, the condenser temperature and the vacuum temperature are basically unchanged, the sublimation heat absorption is relatively stable, and the temperature of the product is relatively constant. As the product dries from top to bottom, the resistance to ice sublimation increases gradually. The product temperature will also increase slightly accordingly. Until the presence of ice crystals cannot be observed with the naked eye. At this point more than 90% of the moisture has been removed. The process of mass sublimation has basically ended so far. In order to ensure that the sublimation of the whole box of products is completed in large quantities, the board temperature still needs to be maintained for one stage before the second stage of heating. The remaining few percent of water is called residual water, which is different from water in free state in terms of physical and chemical properties. Residual water includes chemically bound water and physically bound water, such as combined crystal water crystallization, protein passing through hydrogen Свързаната вода и адсорбирана вода върху твърди повърхности или капиляри и т.н. . Тъй also drop sharply. The maximum drying temperature to ensure product safety should be determined experimentally. Usually we keep the board temperature around +30℃in the second stage and keep it constant. At the beginning of this stage, because the temperature of the board increases, the residual moisture is less and it is not easy to vaporize, so the temperature of the product rises Бързо . Въпреки това, тъй като температурата на продукта и температурата на дъската постепенно се доближават, топлинната проводимост става по -бавна и отнема дълго време, за да чакате търпеливо . практически опит показва, че времето на изсушаване на остатъчната влага е почти равно на времето за голямо количество сублимация, а понякога дори и дори надвишава {{{{{{{{{.
